![]() ![]() Gently pull both ends of the bump-head trimmer line to ensure it's been released from the holding slots. Hold down the wheel to compress the spring, and then screw the bump knob into the head. Place the wheel back onto the shaft, and line up the holding slots with the eyelets on the cutter head.Locate the eyelets on the spring head, and feed the trimmer line through. ![]() Step 4: Reassemble the string trimmer bump head When 6 inches of string remain, push the ends into the holding slots market '0.95"'. Following the direction of the arrow on the top of the wheel, tightly wind the trimmer line around the spool.Insert the short ends of the trimmer line into the other inner reel hole, and then pull the long end of the string to close the loop.Pull them through so that the ends match up, and two to three inches of trimmer line remain. Locate the two holes on the top of the inner real and insert one end of each length of trimmer line into one of the holes.Set aside the spring for now - you'll be wrapping the trimmer line around the inner wheel. Unscrew the bump knob and remove the inner wheel and spring. 095" trimmer line should work, but check your operator's manual to find out exactly what kind of trimmer line to use for your Cub Cadet bump-head string trimmer. ![]() Either 10 feet of twin-strand split line, or two ten-foot lengths of. Step 1: Cut the new trimmer line to lengthīegin by cutting 10 feet of new trimmer line. When you're out of string, follow the step-by-step instructions below to learn how to install trimmer line. Simply bump the cutting head against the ground while it's spinning to release trimmer line. With no blades to sharpen, these yard trimmers are easy to use and maintain. The trimmer works by feeding plastic string out of a cutting head that trims tall grass, weeds and other light brush. Using a traditional bump-head string trimmer is a great way to keep your yard looking sharp. How to install trimmer line in a bump-head string trimmer ![]()
0 Comments
Leave a Reply. |